쇼룸

전기 와이어 로프 호이스트 설치 단계

전기 와이어 로프 호이스트 has two types: fixed and running. Running installation is more common than fixed installation. The installation of fixed electric hoist requires the use of hexagonal bolts, flat washers, spring washers and other accessories. Ensure that the components are installed correctly and tighten the bolts with a torque wrench. Ensure that the fixing ring presses the mounting rod so that the wire rope electric hoist body cannot move or rotate along the mounting rod.

-The electric wire rope hoist is hoisted by a split machine and installed on the beam.

-Before installing the 모노레일 와이어 로프 호이스트, the tracks should be strictly parallel and on the same horizontal plane.

-Before installation, carefully check the components of the monorail wire rope hoist according to the packing list and check carefully. Check the operation records and archive them.

-Before installation, relevant personnel should be organized to carefully study the drawings and solve the deformation and defects caused by improper transportation and storage according to the technical requirements.

-There should be at least two lifting points when lifting. The lifting points should be set in the direction symmetrical to the center of gravity of the equipment and have sufficient rigidity. The lifting points should have cushions. The main tying method is the running wheel or the main beam, and try to choose both ends of the bridge.

-Lift the walking trolley and attach it to one side of the trolley track, fix it and tie it firmly.

-After the 모노레일 와이어 로프 호이스트 is hoisted in place, after hoisting to a certain height, assemble the backpack and other equipment on the electric hoist according to the design requirements of the drawing, and then hoist it all in place.

-When installing, the transportation hook should be cut off first.

-When assembling the 전기 와이어 로프 호이스트, the end beam bolt hole is used as the positioning reference, and the connecting plates at various places are assembled according to the factory number, and the position shall not be changed at will. Use a high-strength wrench to plan the bolt torque value.